Wayne-Dalton 9300 Important The Dimension, Door Operation, 3-1/2”89 MM FOR SMOOTH, SAFE, Section

10	Top Section
Tools Needed:	Place the top section in the opening and vertically
Hammer	align with lower sections.
Nail	Temporarily secure the top section by driving a
	nail in the header near the center of the door and
Tape Measure	bending it over the top section.
Step Ladder	Now flip up hinge leaf against section, fastening
	center hinges first, and end hinges last. (Refer to
	Step 8).
	When installing a door with Torquemaster® Plus
	counterbalance system, vertical track alignment
	is critical.
	Position flagangle between 1-11/16” (43 mm)
	to 1-3/4” (44 mm) from the edge of the door.
	Tighten the bottom lag screw. Flagangles must be
	parallel to the door sections.
	Repeat for opposite side.
	IMPORTANT: THE DIMENSION
	BETWEEN THE FLAGANGLES MUST BE
	DOOR WIDTH PLUS 3-3/8” (86 MM) TO
	3-1/2” (89 MM) FOR SMOOTH, SAFE
	DOOR OPERATION.
	Now complete the vertical track installation by
	securing the center jamb bracket (s), flagangle,
	and connection of the vertical track/ flagangle.
	Repeat for opposite side.

Door width +

3-3/8” - 3-1/2”

NAIL

TOP SECTION

1-11/16” TO 1-3/4”

TOP FLAGANGLE

SECTION

13

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com