19 | Securing Center Bracket Assembly |
Tools Needed: | NOTE: If you are not installing the idrive® opener on |
| your garage door, you must install the center bracket |
Power Drill | bushing assembly, follow these instructions. |
3/16” Drill Bit | IMPORTANT: TORQUEMASTER® SPRING |
| TUBE ASSEMBLY MUST BE LEVEL BEFORE |
7/16” | CENTER BRACKET ASSEMBLY IS FAS- |
Socket Driver | TENED TO HEADER. |
Step Ladder | To locate the center bracket, mark the header halfway |
| between the flagangles and level the TorqueMaster® |
| spring tube assembly. Drill 3/16” pilot holes into |
| header for the lag screws. Fasten the metal bracket |
| to the header using (2) 5/16” X |
|
|
CENTER BRACKET
BUSHING ASSEMBLY
(2) 5/16” X
HEX HEAD LAG
SCREWS
2019 |
| Securing Door | |
| for Spring Winding | ||
Tools Needed: | Place vice clamps onto both vertical tracks just | ||
| above the third roller. This is to prevent the garage | ||
(2) Vice Clamps | door from raising while winding counterbalance | ||
| springs. | ||
|
|
|
|
|
| WARNING | |
| FAILURE TO PLACE VICE CLAMPS | ||
| ONTO VERTICAL TRACK CAN | ||
| ALLOW DOOR TO RAISE AND | ||
| CAUSE SEVERE OR FATAL | ||
| INJURY. |
PLACE VICE
CLAMPS ABOVE
3RD ROLLER (BOTH SIDES)
TRACK
VICE CLAMPS
ATTACHED TO
INNER RAIL
OF TRACK
18
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at