Wayne-Dalton 9300 to Vertical Track, Horizontal Angle, 2Attaching Fully Adjustable Flagangle

2Attaching Fully Adjustable Flagangle

to Vertical Track

Tools Needed:	NOTE: If quick install flagangles were installed in
None	Step 1, skip this step and continue with Step 3.
	Hand tighten the flagangle to the vertical track
	using (1) stud plate and (2) 1/4” - 20 flange hex
	nuts. Repeat for other side.
	Secure the flange nuts after flagangle spacing is
	complete (Step 10).

Fully adjustable flagangle

(2) 1/4”- 20 Flange	Stud plate
hex nuts

Vertical track

3		Hole	Tabs	Horizontal angle
	Horizontal Angle
				Key hole slot
Tools Needed:	Position the horizontal angle as shown.
Hammer	Place tabs of horizontal angle in the key slot of	Hole
	horizontal track. Using a hammer, tap the horizontal
	angle towards the curved end of the track until the
	holes in track and angle are aligned. Repeat for			Horizontal track
	opposite side. Set tracks aside.
	NOTE: For larger doors, a full length horizontal angle	Horizontal angle
	may be spot welded to the horizontal track. If the
	horizontal angle is not welded, the horizontal angle
	must be installed as shown.
				Horizontal angle
			Horizontal track
				Horizontal track
				Tabs

8

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com