Installation
Begin the installation of the door by checking the opening. It must be the same size as the door. Vertical jambs must be plumb and header must be level. Side clearance, from edge of door to wall, must be a minimum of
IMPORTANT: STAINLESS STEEL OR PT 2000 COATED LAG SCREWS (NOT SUPPLIED) MUST BE USED WHEN INSTALLING CENTER BEARING BRACKETS, END BRACKETS, JAMB BRACKETS, OPERATOR MOUNTING/SUPPORT BRACKETS AND DISCONNECT BRACKETS ON TREATED LUMBER
IMPORTANT: WHEN INSTALLING 5/16” DIAMETER LAG SCREWS USING AN ELECTRIC DRILL/DRIVER, THE DRILL/DRIVER’S CLUTCH MUST BE SET TO DELIVER NO MORE THAN 200 IN. LBS. OF TORQUE. FASTENER FAILURE COULD OCCUR AT A HIGHER SETTING.
NOTE: It is recommended that 5/16” lag screws be pilot drilled using a 3/16” drill bit, prior to fastening.
1 | Attaching Quick Install Flag | QUICK INSTALL TAB UNLOCKED | QUICK INSTALL TAB LOCKED |
|
| ||
Angle to Vertical Track |
|
| |
Tools Needed: | NOTE: If you have fully adjustable flagangles, skip |
|
|
|
|
| |
None | this step and complete Step 2. |
|
|
|
|
| |
| Place the lower quick install tab of the flagangle in |
|
|
| the quick install feature of the vertical track. Give |
|
|
| the flagangle 1/4 turn to lock in place. Repeat for |
|
|
| other side. | FLAGANGLE | FLAGANGLE |
| NOTE: After completing this step, continue with |
|
|
| Step 3. |
|
|
|
| VERTICAL | VERTICAL |
|
| TRACK | TRACK |
|
| LEFT HAND TRACK AND FLAGANGLE | RIGHT HAND TRACK AND FLAGANGLE |
|
|
| 7 |
INSTALLATION
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at