Wayne-Dalton 9300 Important The Tops Of The, The Shim, Level Bottom Section, Jamb Bracket, Track

6	Bottom Section
Tools Needed:	Center the bottom section in the door opening.
Level	Level section using wooden shims (if necessary)
	under the bottom section.
Wooden shims
(If necessary)

	OPENING
DOOR	SEAL
WEATHER
WITH

LEVEL

BOTTOM

SECTION

WOODEN SHIMS (IF NECESSARY)

7	Vertical Track
Tools Needed:	IMPORTANT: THE TOPS OF THE
3/16” Drill Bit	VERTICAL TRACKS MUST BE LEVEL
	FROM SIDE TO SIDE. IF THE BOTTOM
	SECTION WAS SHIMMED TO LEVEL IT.
Power Drill	THE VERTICAL TRACK ON THE SHIMMED
	SIDE, MUST BE RAISED THE HEIGHT OF
7/16” Socket Driver	THE SHIM.
Tape Measure	Position the left hand vertical track assembly
	over the rollers of the bottom section. Make sure
Level	the counterbalance cable is located between the
	rollers and the door jamb. Drill 3/16” pilot holes for
Step Ladder	the lag screws.
	Loosely fasten jamb brackets and flagangle to the
	jamb using 5/16” x 1-5/8” lag screws. Tighten
	lag screw securing bottom jamb bracket to jamb,
	maintaining 3/8”- 5/8” track spacing.
	NOTE: Hang cable drum over flagangle.
	Repeat for the right hand side.

JAMB

BRACKET

FLAGANGLE

VERTICAL

TRACK

ASSEMBLY

5/16” X 2”

LAG SCREWS

BOTTOM

SECTION

VERTICAL TRACK

ROLLER BOTTOM SECTION

3/8”-5/8”

LAG	LAG
	SCREW
SCREW
	LOCATIONS
LOCATIONS
12R QI FLAGANGLE	15R QI FLAGANGLE
	QUICK INSTALL
	JAMB BRACKET
LAG
SCREW
LOCATIONS
	LAG
12R & 15R FULLY	SCREW
ADJUSTABLE FLAGANGLE

11

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com