Wayne-Dalton 9300 Table of Contents, Definition of key words used in this manual

Models: 9300

1 28
Download 28 pages 41.25 Kb
Page 2
Image 2
Table of Contents

Table of Contents

 

Important Safety Instructions

2

Package Contents

3

Door Section Identification

4

Tools Required

5

Pre-Installation

3-6

Removing An Existing Door

5

Preparing The Opening

6

Installation

7-22

Torquemaster Plus Reset Instructions

23-25

Optional Installations

25-26

Side Lock

25

Pull Rope

26

Trolley Operator

26

Maintenance

26

Cleaning

26

Warranty

27

Customer Service Number

28

Definition of key words used in this manual:

Definition of key words used in this manual: WARNING

INDICATES A POTENTIALLY HAZARDOUS SITUATION WHICH, IF NOT AVOIDED, COULD RESULT IN SEVERE OR FATAL INJURY.

CAUTION: PROPERTY DAMAGE OR INJURY CAN RESULT FROM FAILURE TO FOLLOW INSTRUCTIONS.

IMPORTANT: REQUIRED STEP FOR SAFE AND PROPER DOOR OPERATION.

NOTE: Information assuring proper installation of the door.

1.READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS. WARNING

TO AVOID POSSIBLE INJURY, READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING INSTALLATION. IF IN QUESTION ABOUT ANY OF THE PROCEDURES, DO NOT PERFORM THE WORK. INSTEAD, HAVE A TRAINED DOOR SYSTEMS TECHNICIAN DO THE INSTALLATION OR REPAIRS.

1.READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.

2.Wear protective gloves during installation to avoid possible cuts from sharp metal edges.

3.It is always recommended to wear eye protection when using tools, otherwise eye injury could result.

4.Avoid installing your new door on windy days. Door could fall during the installation causing severe or fatal injury.

5.Doors 12’- 0” wide and wider should be installed by two persons, to avoid possible injury.

6.Operate door ONLY when it is properly adjusted and free from obstructions.

7.If a door becomes hard to operate, inoperative or is damaged, immediately have necessary adjustments and/or repairs made by a trained door system technician using proper tools and instructions.

8.DO NOT stand or walk under a moving door, or permit anybody to stand or walk under an electrically operated door.

9.DO NOT place fingers or hands into open section joints when closing a door. Use lift handles/gripping points when operating door manually.

10.DO NOT permit children to operate garage door or door controls. Severe or fatal injury could result, should the child become entrapped between the door and the floor.

11.Due to constant extreme spring tension, DO NOT attempt any adjustment, repair or alteration to any part of the door, especially to springs, spring brackets, bottom corner brackets, red colored fasteners, cables or supports. To avoid possible severe or fatal injury, have any such work performed

by a trained door systems technician using proper tools and instructions.

12.On electrically operated doors, pull down ropes must be removed and locks must be removed or made inoperative in the open (unlocked) position.

13.Top section of door may need to be reinforced when attaching an electric opener. Check door and/or opener manufacturer’s instructions.

14.VISUALLY inspect door and hardware monthly for worn and or broken parts. Check to ensure door operates freely.

15.Test electric opener’s safety features monthly, following opener manufacturer’s instructions.

16.NEVER hang tools, bicycles, hoses, clothing or anything else from horizontal tracks. Track systems are not intended or designed to support extra weight.

17.Avoid installing your door in close proximity to any heat source that may exceed 200° F. Failure to due so, may cause door sections to

blister and/or warp.

After installation is complete, fasten this manual near garage door.

2

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Page 2
Image 2
Wayne-Dalton 9300 Table of Contents, Definition of key words used in this manual, blister and/or warp