CLEANING SIDE BURNER TUBE
Remove Side Burner Valve
You will need: A Phillips screwdriver.
A)Remove the two screws that secure the side burner valve plate to the side burner table (1).
B)Release the side burner valve from burner tube by gently pulling the assembly forward (2). Use care not to kink the corrugated gas line (3).
Clean the Burner Tube
You will need: A flashlight, a wire (a
A)Look inside the burner tube with a flashlight (4).
B)Clean any debris or blockage from the inside of the tube with the wire (5).
Reinstall Side Burner Valve
You will need: A Phillips screwdriver.
A) Align side burner valve with side burner tube opening.
mCAUTION: The side burner tube opening (6) must be positioned properly over the side burner valve orifice (7).
B)Secure the side burner valve plate to the side burner table using two screws.
SIDE BURNER MAINTENANCE
mWARNING: All gas controls and supply valves should be in the off (
) position.
•Make sure black igniter wire and white ground wire are attached to the igniter module inside the base cabinet.
Refer to the “IGNITER MODULE WIRE GUIDE.”
•Check that the wires are not kinked.
•Make sure the electronic igniter button is working by listening for clicking and looking for sparks at burner.
•The sparks should be a white/blue color, not yellow.
ROUTINE MAINTENANCE
1 | 4 |
|
|
5
2
6
7
3
SIDE BURNER EXPLODED VIEW
Side Burner Grate
Side Burner Head
Side Burner Tray
Side Burner Table
Side Burner Control Knob
WWW.WEBER.COM® 31
