Weber PL - PG. 59 57205 Main Burner Ignition & Usage, m DANGER, Lighting with a Match, can cause

MAIN BURNER IGNITION & USAGE

MAIN BURNER IGNITION

Lighting with a Match

A) Open the grill lid (1).

m DANGER 1

Failure to open the lid before igniting the grill’s burners, or not waiting five minutes to allow the gas to clear if the grill does not light, may result in an explosive flare-up which can cause serious bodily injury or death.

B) Make sure ALL burner control knobs are turned

off (2). Check by pushing control knobs in and turning them clockwise until they stop.

m WARNING: The burner control knobs	2
must be in the off ( ) position before
you turn on the LP cylinder valve. If
they are not in the off ( ) position
when you turn on the LP cylinder
valve, the “excess gas flow control”
feature will activate, limiting the flow	of

gas from the LP cylinder. If this should occur, turn off the LP cylinder valve and burner control knobs. Start over.

	m DANGER
When the “excess gas flow control”
feature is activated, a small amount of gas
is still flowing to the burners. After turning			3
off the LP cylinder valve and burner
control knobs, wait at least five		minutes
for the gas to clear before attempting to
light the grill. Failure to do so may result
in an explosive flare-up, which		can cause
serious bodily injury or death.
			4
C)	Turn the LP cylinder on by SLOWLY turning the
	cylinder valve counterclockwise (3).
D)	Put match in the matchstick holder and strike match.
	Insert matchstick holder with lit match down through
	the cooking grates, past the Flavorizer® bars and next
	to burner 1 (4).
E) Push burner 1 control knob in and turn it
	counterclockwise to start/high ( ) position (5).
	IMPORTANT: Always ignite burner 1 first. The other
	burner(s) ignite from burner 1.
F)	Check that burner 1 is lit by looking through the
	cooking grates. You should see a flame.

mWARNING: Do not lean over the open

grill.

m WARNING: If burner 1 fails to ignite 5 within five seconds, stop, turn the

burner control knob to off and wait five minutes to allow the gas to clear before you try again.

G) After burner 1 is lit, you can turn on burner 2 (and burner 3).

TO EXTINGUISH BURNER

Push each burner control knob in and turn it clockwise to the off ( ) position. Turn gas supply off at the source.

WWW.WEBER.COM® 19