METHODS OF BURNER IGNITION
There are two ways to ignite burner 1. The first is by using the electronic Crossover® ignition system built into your grill. The second is with a match.
Next are the steps for igniting your grill using the electronic Crossover® ignition system.
On the following page are steps for igniting your grill with a match.
Summary lighting instructions are inside the cabinet door.
MAIN BURNER IGNITION & USAGE
MAIN BURNER IGNITION
Electronic Crossover® Ignition System
The electronic Crossover® ignition system ignites burner 1 with a spark from the igniter electrode inside the Gas Catcher™ ignition chamber. You generate the energy for the spark by pushing the igniter button. You will hear the igniter clicking. Burner(s) 2 (and 3) can be lit after burner 1 is lit.
A) Open the grill lid (1).
m DANGER
Failure to open the lid before igniting the grill’s burners, or not waiting five minutes to allow the gas to clear if the grill does not light, may result in an explosive
B) Make sure ALL burner control knobs are turned
off (2). Check by pushing control knobs in and turning them clockwise until they stop.
m WARNING: The burner control knobs must be in the off ( ) position before you turn on the LP cylinder valve. If they are not in the off ( ) position when you turn on the LP cylinder valve, the “excess gas flow control” feature will activate, limiting the flow of gas from the LP cylinder. If this should occur, turn off the LP cylinder valve and burner control knobs. Start over.
m DANGER
When the “excess gas flow control” feature is activated, a small amount of gas is still flowing to the burners. After turning off the LP cylinder valve and burner control knobs, wait at least five minutes for the gas to clear before attempting to light the grill. Failure to do so may result in an explosive
1
2
3
4
Some batteries have a plastic protective wrap around them. This plastic must be removed before you attempt to ignite your grill with the electronic Crossover® ignition system. Do not confuse this plastic with the battery label.
C)Turn the LP cylinder on by SLOWLY turning the cylinder valve counterclockwise (3).
D)Push burner 1 control knob in and turn it counterclockwise to start/high ( ) position (4).
IMPORTANT: Always ignite burner 1 first. The other burner(s) ignite from burner 1.
E)Push and hold in the igniter button (5). You will hear the igniter clicking.
F)Check that burner 1 is lit by looking through the cooking grates. You should see a flame.
mWARNING: Do not lean over the open grill.
mWARNING: If burner 1 fails to ignite within five seconds, stop, turn the burner control knob to off and wait five minutes to allow the gas to clear before you try again or light with a match.
G)After burner 1 is lit, you can turn on burner 2 (and burner 3).
TO EXTINGUISH BURNER
Push each burner control knob in and turn it clockwise to the off ( ) position. Turn gas supply off at the source.
5
18WWW.WEBER.COM®
