NPS-2HDHeavyDutyNetworkPowerSwitch;User'sGuide

2.2. Back Panel

Figure2.2:BackPanel

￿Bus 2 (Plug 2): Includes the following components:

A)Power Inlet: Supplies power for Bus 2.

B)Circuit Breaker: 115 VAC, 20 Amps

C)Switched Outlet: Each bus can switch up to 20 Amps.

￿Bus 1 (Plug 1): Same as Item 1 above, except the Bus 1 Power Inlet supplies power to Bus 1.

￿Network Port and Activity Indicator: A 10BaseT, RJ45 Ethernet port for connection to your TCP/IP network. To communicate via Network, you must first specify network parameters as described in Section 5.6.

Note: The NPS-2HD features a 10BaseT interface. When connecting the NPS to a 100BaseT interface, note that most 100BaseT router switches will autosense to determine if the device is 100BaseT or 10BaseT and then configure the network interface accordingly. If your router switch does not autosense, then the network interface port must be manually set to 10BaseT.

￿Modem Port: A Male RS-232, DB9 Connector, DTE configuration. For connection to an external modem.

￿Console Port: A Male RS-232, DB9 Connector, DTE configuration. For connection to a local PC.

￿Option Switches: A bank of four DIP Switches which select default settings for the baud rate and other features.

￿Default Button: Used in conjunction with the Reset Button to reset the unit to defaults (see Section 4.3.)

￿Reset Button: Used in conjunction with the Default

2-2Button to reset the unit to defaults (see Section 4.3.)

Page 10
Image 10
Western Telematic NPS-2HD manual Back Panel, Circuit Breaker 115 VAC, 20 Amps