Western Telematic NPS-2HD manual Other Commands, Login as Different User, Reset Network Port

Operation

6.6. Other Commands

6.6.1.Login as Different User

The /R command is used to re-login using a different password. When invoked, the NPS will display the password prompt, allowing the user to enter a different password in order to access the other plug or System Level command functions. The /R command is typically used to switch from User Mode to System Mode.

The /R command is available in both System Mode and User Mode. To login as a different user, type /R, press [Enter], and then key in a different valid password at the prompt. To suppress the "Sure?" prompt, type /R,Y [Enter].

6.6.2.Reset Network Port

The /T command is used to reinitialize the NPS Network card. The /T command is not available in User Mode. To reset the Network Port, type /T and press [Enter]. To suppress the "Sure?" prompt, type /T,Y [Enter].

Note: The /T command can only be issued via the Console Port or Modem Port. The /T command cannot be invoked via the Network Port.

6.6.3.Exit / Disconnect

To exit from the NPS Command Mode and discontinue connection to the unit, type /X and press [Enter]. The NPS will display the "DISCONNECT" message. To suppress the "Sure?" prompt, type /X,Y [Enter].

Note: Only one port may access the NPS command
mode at any given time. In order to allow access to
the NPS unit via other ports, always exit from the
command mode when you are finished
communicating with the unit. For more information,
please refer to Section 6.8.	6-7