Western Telematic NPS-2HD manual

NPSFigure43BotDelay:21PLUGEnter.-2HDPo#15assword:lugSelection.4:HeavyPARAMETERS:Name:PlugUpDefault:DutyParametersorNetwork<ESC>On5Power(undefined)toMenuSecExitSwitch;(Plug...User's1Shown)Guide

2.Password: (Up to 16 Characters) Assigns a User Password to this plug. When a User Password is assigned, the plug is then "owned" by that password. When a User Password is entered at login, the user will have access to only the plug(s) which are owned by this password. (Default = undefined).

Notes:

￿If you wish to allow a single user to access both switched plugs, assign the same User Password to both plugs.

￿If the System Password is defined, and the plug's User Password is not defined, then the System Password will "own" this plug, and only the System Mode will be able to control the plug.

3.Boot Delay: During a Boot cycle, power to the plug is first switched off and then switched back on. The Boot Delay is the length of time which elapses between the time when power is switched off and the time that power is restored. The Boot Delay can be 1, 5, 10, 15, 30 or 60 seconds. (Default determined by Option Switch 2; Factory Setting = 5 Seconds).

4.Power-Up Default: Determines how this plug will react when the /D (default) command is invoked, or after a power interruption. Each plug can be automatically switched On or Off as specified by the Power-Up Default. (Default = On).

After Plug Parameters have been defined, press [Esc] to exit 5-8from the Plug Parameters menu.