NPS-2HDHeavyDutyNetworkPowerSwitch;User'sGuide

7.2. Restoring Saved Parameters

This section describes the procedure for using ProComm to send saved parameters to the NPS-2HD.

1.Start your communications program and access the NPS command mode using the System Level Password.

2.Configure your communications program to upload an ASCII text file.

3.Upload the file with the saved parameters. If necessary, key in the file name and directory path.

4.When the upload is complete, make certain to terminate the communications program's upload mode.

Note:

￿The current On/Off status of each NPS-2HD plug will not be saved or restored. However, the selected default On/Off setting for each plug will be saved and restored.

￿When the configuration file is sent to the NPS-2HD via telnet, the unit's IP Address, Subnet Mask, and Gateway Address cannot be altered.

5.Type /SP and press [Enter], the NPS-2HD will display the Status Screen with passwords revealed. Check the Status Screen to make certain that saved parameters have been restored.

7-2

Page 42
Image 42
Western Telematic NPS-2HD manual Restoring Saved Parameters