NPS-2HDHeavyDutyNetworkPowerSwitch;User'sGuide

4.2. Option Switches

The Option Switches select default settings for the Baud Rate, Command Echo, Boot Delay and Disconnect Timeout. Default settings selected via the Option Switches will be used when the unit is reset to default parameters as described in Section 4.3.

Notes:

Although the Option Switches select default settings for these features, the NPS-2HD configuration menus can also be used to select operating parameters as described in Section 5.

If Option Switch settings are changed, the new settings will not be applied until the unit is reset as described in Section 4.3.

Option Switch settings are described below:

Baud Rate: The default baud rate for the Console Port and Modem Port.

Boot Delay: The default Boot Delay setting. When a boot cycle is initiated, the Boot Delay determines the length of time that the switched outlet will remain off until power is restored.

Command Echo: The default setting for the Command Echo for the Console Port, Modem Port and Network Port. When enabled, commands entered at your keyboard will be sent to the NPS and echoed back to your display monitor.

Switch1234

DefaultFunctionBCDisconnectaudotmmandDelayRateEchoTimeout 383010Enable.4KUpMinSecbps9600. Disable*2Min*5DownSecbps*.

Disconnect Timeout:

The default Disconnect Timeout value.

This determines h

w lo

g the NPS will wait for add tional

commands before

utom

tically disconnecting. Note that

when the NPS times

ut,

R will drop, and the modem

disconnect and initialize s rings will be sent.

4-4

* = Factory Setting

 

 

Page 18
Image 18
Western Telematic NPS-2HD manual Option Switches, Disconnect Timeout