Refreshment Center Operators’ Guide Tray Set-Up
December 2004 29 4800006
Install a Spiral Coupler
1. Place the gear in position if one is required for this set-up.
When Used with a Motor:
2. Hold the motor in place
and push the spiral
coupler through the motor
gear box until it clicks into
position. Be sure the
spiral couplers are
oriented as shown below.
NOTE
The motor output shaft
opening contains eight facets
to allow the spiral coupler to
be installed in any one of
eight positions.
Spiral Coupler Orientation
When Used with a Coupler Bearing:
3. Hold the coupler bearing in place and push
the spiral coupler through the bearing until
the coupler clicks into position. Be sure the
coupler is in the proper orientation as
shown.
MOTOR
SPIRAL
COUPLER
FRONT VIEW OF
MOTOR OUTPUT SHAFT
LEFT SPIRAL
COUPLER RIGHT SPIRAL
COUPLER
AS VIEWED FROM FRONT OF TRAY
ONE POSITION
C
OUNTERCLOCKWISE
FROM VERTICAL
ONE POSITION
CLOCKWISE
FROM VERTICA
L
SPIRAL
COUPLER
SPIRAL
B
EARING