Refreshment Center Operators’ Guide Programming Procedures
December 2004 67 4800006
COUPLE/UNCOUPLE TRAY MOTORS
Two motors may be electronically coupled to turn together to vend a wide product. In some
cases, you may need to connect or disconnect the wire harness from a specific motor. See
"Set Up A Tray To Vend Wide Products" on page 18.
NOTE:
An even numbered motor (0, 2, 4, etc.) may only be
coupled to an odd numbered motor (1, 3, 5, etc.)
1. Press , then press until the display shows .
2. Press the letter of the tray you want to couple, or press to couple motors on tray
A, then press to get to the desired tray.
COUPLE ADJACENT MOTORS:
a. The display shows . This display means that on the A tray, all
adjacent motors (0 and 1, 2 and 3, etc.) are coupled.
NOTE:
The +s and As represent motor positions 0 through 9.
b. On the control panel, press the EVEN motor number of the pair you wi sh to couple or
uncouple. In our example, to uncouple motors 0 and 1, press 0. The display will
now show .
COUPLE NON-ADJACENT MOTORS:
a. Disconnect the motor(s) between the two you want to couple. See "Connect and
Disconnect a Motor Harness" on page 24 for information on how to do this. The
display shows . This display means that on the A tray, adjacent
motors 0 and 1 are NOT coupled, 2 is coupled to 5, 6 is coupled to 7, and 8 is
coupled to 9.
NOTE:
The +s and As represent motor positions 0 through 9. If a motor is
disconnected or not present (motors 3 and 4 in this example),
its position is replaced by an empty space.
b. On the control panel, press the motor number of the even moto r of the m otor p air you
wish to couple or uncouple. For example, to uncouple motors 2 and 5 , pre ss 2. The
+ representing motor number 2 changes to a C. Please note that the left motor of a
coupled pair MUST be an even-number ed motor.
3. CONTINUE.