Refreshment Center Operators’ Guide Introduction
December 2004 5 4800006

MAIN CONTROLLER PCB DISPLAY. This display consists of two light emitting diodes

(LED) mounted on the controller PCB.

"CAUTION - Risk of explosion if battery is replaced with an incorrect type. Dispose of used batteries according
to the manufacturer's instructions."
POWER ON
(LED 1) When lit, this red LED indicates electrical power is applied to the
controller PCB.
HEARTBEAT
(LED 2) When flashing, this red LED indicates that the controller PCB is
active, and the software is operating.
Back Side of U.S./Canada Power Panel. The
circuit board mounted on the rear of the po wer
panel is a DC power supply for the coin
mechanism. A fuse protects the b oard circuitry in
the event of a coin mechanism sole noid failure. If
the coin mechanism is not working, check this
fuse. If the fuse is blown, a bad coin mechanism
solenoid could be at fault.

NORMAL CONDITIONS:

When the merchandiser is operating normally, you should see a steady red

POWER ON indicator and a flashing red HEARTBEAT indicator. Contact a

service representative if any other condition exists.

DC POWER
SUPPLY PCB
F
OR 110V COIN MECH
˜
AGC
1
FUS
E
1 AM
P
TOP
BACK SIDE
OF
U.S. / CANADA POWER CONTROL PANEL