Refreshment Center Operato rs’ Guide Final Installation
December 2004 45 4800006
Install the Base Plate
Refer to the figure below while completing the following procedures:
WARNIN G
Do not move the cabinet while the hex head screws and/or carriage bolts are
loosened. The cabinet would be unstable and could tip and cause injury.
1. Loosen the left leg assembly hex screws to allow mounting a base plate bracket.
2. Secure one of the base plate brackets to the leg assembly and tighten the hex screws.
3. Loosen the right leg assembly hex screws to allow mounting the other base plate
bracket.
4. Secure the other base plate bracket to the right leg assembly using the two hex head
screws. Tighten the hex head screws.
5. Insert the short arms of the slides into the hinged tabs of the base plate. Position the
slide so the notch near the short arm is on the bottom side.
6. Insert the long arms of the slides into the base plate brackets.
7. Insert and secure a cotter pin through the hole in the back of each of the slides.
8. Push the base plate toward the merchandiser cabinet. The front tabs of the base plate
brackets should seat in the notches in the long arms of the slides.