Refreshment Center Operators’ Guide Tray Set-Up
December 2004 19 4800006
6. Do one of the following:
a. If your group has an ODD number of spirals (3, 5, etc.) remove the harnesses from
all motors in the group except the left most one. To the right most motor, connect the
harness from the motor immediately to its left.
b. If your group has an EVEN number of spirals (4, 6, etc.) remove the harnesses from
all motors inside the group (leave the harnesses connected to the left most an d right
most motors).
7. Install a spiral at the right most position in your group. Make sure it has the same
product capacity and is opposite to the one in the left most position.
8. Return the tray to the merchandiser.
9. Electronically couple the motors as needed (see "Couple/Uncouple Tray Motors" on
page 67).
10. Return to step 3 in the "Set up Trays to Vend Products" on page 18.
Study this procedure before you i ns ta ll a tr ay for the fi rst time; w hile yo u ar e ho ldi ng th e tray
you will not be able to see this area.
Remove a Snack or Candy Tray
1. Remove all product from the tray.
2. Push down on the tray latches
with your thumbs.
3. Pull the tray toward you until you
hear and feel the rear tray rollers
drop into a cut-out in the top of
the guide rail.
PULL
TRAY
LATCH
TRAY
LATCH
TRAY
LATCH
TRAY
GUIDE
RAIL