Refreshment Center Operators’ Guide Initial Set-Up

December 2004 9 4800006
Open the Rear Outlet Diffuser
The rear outlet diffuser vents warm air up and out of the back of the merchandiser, away
from the air inlet (on the bottom of the cabinet). It is shipp ed i n th e closed positi on and must
be opened before the merchandiser is put into service.
1. Remove the two screws holding
the upper corners of the diffuser
against the back of the cabinet.
Notice the two unused screw holes
at the corners.
NOTE:
Wear protective gloves when
bending diffuser to prevent
injury.
2. Pull the top of the diffuser away
from the cabinet, then bend the
diffuser so that the unused screw
holes align with the holes in the
cabinet.
3. Use the two screws removed in
step one to affix the diffuser to the
cabinet in its new “open” position.
CAUTION
The merchandiser will not function properly if the Rear Outlet Diffuser is not open!
Position the Merchandiser
Move the merchandiser to its approximate position. There are certain procedures you
need to perform before it is in its permanent location. Plug in your merchandiser and turn
the power switch to ON.
• You can position this merchandiser anywhere in a bank of machines. It can even
be placed on an end flush against a side wall.
• The merchandiser should be placed at least four inches away from the back wall
(six inches if rear diffuser is not installed). This will provide adequate air circula tion
for the refrigeration unit. This will provide adequate air circulation for the
refrigeration unit.
• The merchandiser will operate more efficiently when placed in a shaded location.
• There should be enough room in front of the merchandiser for the door to move
freely.
CAUTION
This machine is only rated for installation at an indoor location.