Tray Set-Up Refreshment Center Operators’ Guide
4800006 30 December 2004
Move a Tray Up or Down
This merchandiser can be adjusted to vend taller products. Follow the guidelines below:
• Keep in mind that when you increase the product height available to a tray by
lowering it, you will be decreasing the product height available to the tray below.
• If a tray is in the lowest position, the tray below it shou l d no t be in the high est po si tion.
• If a tray is in the highest position, the tray above should not be in the lowest position.
• You may need to experiment with various tra y position s to get the best resul ts fo r your
products. CAUTION
The trays in should not be positioned over an open air discharge vent.
NOTE
Tray movement is limited because the tray harness will limit the amount of
travel available to the tray guide rails.
Proceed as follows:
1. Remove the tray from
the merchandiser. (See
"Remove a Snack or
Candy Tray" on page
19).
2. Remove th e screw th at
secures the right tray
guide rail to the front
guide mounting
channel as shown.
3. Tap up on the guide rail
and unseat the guide
rail tabs from the
channel slots.
4. Pull th e gu ide r ail awa y
from the front and rear
guide mounting
channels.
5. Move the guide rail to
the desired position.
6. Insert the guide rail tabs into the mounting channel slots as shown.
7. Tap down on the guide rail to seat the tabs in the channel slots.
8. Replace the screw that secures the guide rail to the front guide mounting channel.
9. Repeat steps 2 through 8 for the left guide rail.
10. Return the tray to the merchandiser.
(See "Install a Tray in the Merchandiser" on page 31).
11. Load products into the trays, and perform test vends. Make sure the trays don't interfere
with the products you are vending, and that all products vend properly.
SCREW
CHANNEL
SLOT
FRONT GUIDE
MOUNTING CHANNEL
REAR GUIDE
MOUNTING CHANNEL
TRAY
GUIDE
RAIL
PC BOARD