Refreshment Center Operators’ Guide Tray Set-Up
December 2004 31 4800006
Install a Tray in the Merchandiser• Study this procedure before you install a tray for the first time; while you are
holding the tray you will not be able to see this area. Proceed as follows:
NOTE:
Does not apply to bottle trays.
1. Insert the tray so that the tray rollers
pass over the tray guide rollers.
2. Bring th e tray rol ler to r est on the tray
guide.
3. Tilt the tray upward.
4. Connect the tray wiring harness to
the PC board mounted to the guide
rail JUST ABOVE the tray you are
installing.
5. Hold the tray up while pushing it toward the
rear. Stop when the tab on the tray aligns
with the opening in the tray guide.
6. Lower the tray until it rests on the tray guide
roller. Push the tray in all the way.
7. The tray latch will fall into the locking
position.
TRAY
ROLLER
TRAY
GUIDE
REAROF
TRAY
FRONTOF
RAIL
157P0024
TRAY
ROLLER
TRAY
GUIDE
RAIL
REAR OF TRAY
157P0026
CUT-OUT
TAB
157P0012
CUT-OUT
TAB
(ON TRAY)
REAR OF
TRAY
TRAYGUIDE
RAIL
157P0025