Refreshment Center Operators’ Guide Tray Set-Up
December 2004 27 4800006
Remove and Install a Spiral Motor
Remove a Spiral Motor:
NOTE
Some steps may already be completed
1. Remove the tray. (See "Remove a
Snack or Candy Tray" on page 19).
2. Disconnect the motor harness.
(See "Connect and Disconnect a
Motor Harness" on page 24).
3. Remove the spiral.
(See "Remove and Install Spirals"
on page 25).
4. Remove the spiral coupler.
(See "Remove a Spiral Coupler"
on page 26).
5. Lift the motor clear of the tray.
6. Return the tray to the merchandiser.
(See "Install a Tray in the
Merchandiser" on page 31).
Install a Spiral Motor:
1. Remove the tray. (See "Remove a Snack or Candy Tray" on page 19).
2. Place the motor in the correct position at the rear of the tray as shown.
3. Place a gear in position if required by this set-up.
4. Install a spiral coupler in the proper orientation. (See "Install a Gear" on page 28).
5. Connect the motor harness.
(See "Connect and Disconnect a Motor Harness" on page 24).
GEAR
SPIRAL
COUPLE
R
BACKWALL
OF TRAY

˜

SPIRAL
MOTOR