Refreshment Center Operators’ Guide Programming Procedures
December 2004 69 4800006
1. Press , then until the display shows
2. Press the letter of the tray you want to link, or press to link mo tors on tr ay A, the n
press down until desired tray.
3. The display shows This display means that on the A tray, no adjacent
motors are linked.
4. Press the selection number to toggle that motor of the tray between FIFO and no FIFO.
NOTE:
Fifo motors are shown as “>” in place of the tray letter in the motor position.
The “>” means that this motor is linked to the motor to the right. For coupled
motors, the even motor will show + and the odd motor will show “>”. The last
motor on a tray cannot have a “>”. A ”?” is displayed if a motor was originally
marked as FIFO but now is not present. A “X” is displayed if the motor is FIFO
linked but not present. A “O” is displayed if the motor is the last of a FIFO link
but not present.
EXAMPLE:
The display shows tray A as >> The display is telling you that
selctions A2, A3, and A4 are all linked together and are using the FIFO mode.
5. Press to link the whole tray together.
6. Press to unlink all motors on a tray.
7. CONTINUE.
SHOW THE TEMPERATURE IN STANDBY MODE
(Supervisor Mode Only)
1. Follow the steps in "Gain Access to The Supervisor Mode" on page 55.
2. Press , then until something like odisplays.
3. Press an apostrophe is added before the temperature ‘o. Close the door.
The temperature will display in the ready message once the temperature setpoint is met.
4. CONTINUE.