Programming Procedures Refreshment Center Operators’ Gu ide
4800006 92 December 2004
ROM checksum failure. The unit will disa ble itself until the error is
corrected. Replace the validator.
One of the sensors in the bill valid ator has failed. The unit will disab le
itself until the error is corrected. Check for bill s t uc k in t he
acceptance path. If no bil l is present, replace th e va l idator. Cycle
machine power OFF and then ON.
The stacker is open or removed. The unit w ill disable itself until the
error is corrected. Install the stacker correctly.
The stacker is full of bills. Remove bills fro m th e s tack er.
Error exists on tray A, B, C, etc. Motor may be jammed, not home, or
a couple error exists.
(The * is flashing.) Jammed door.
(The 2 is flashing.) Door seen as open an d closed.
(The 3 position is flashing.) Could not find the closed position.
(The 2 position is flashing.) Could not find the open position.
(The 1 position is flashing.) The loading door is open.
(The 3 position is flashing.) Not in the shut position.
ºRefrigerated products went out of se rv ic e on date-time MM/DD/YY
HR.MN because of a health MM/DD/ YY HR.MN control error. The
maximum temperature reached af te r th is ti m e w as X XºF.
Refrigerated products went out of se rv ic e on health control. Only
trays A and B are available.
Refrigerated products went out of se rv ic e on health control. Only
trays A, B, and C are available.
One of the motor sensor lines is idli ng in an incorrect state. This error
could indicate a bad interface board or a bad or pinched harness.
Disconnect the harness and see if th e er ror disappears. If so, the
harness is to blame. If not, suspect th e int e rface board.
- indicates an error in the snack matrix (section)
- indicates an error in the even home line
- indicates an error in the odd home line
- indicates an error in both odd and even home lines
- indicates an error in the can unit (if availab le)
Key(s) x, y stuck.
This error is generated i f the freevend key switch is on, but the
machine is not configured with free w/ k ey.
ERROR MESSAGES (CONTINUED)