Tray Set-Up Refreshment Center Operators’ Guide
4800006 26 December 2004
To Remove a Spiral:
1. Pull forward on the retaining clip and remove the end of
the spiral from the spiral coupler as shown.
2. Remove the spiral from the tray.
To Install a Spiral:
1. Pull the bottom of the retaining clip toward the front of the
spiral.
2. Lower the spiral into the tray column and insert the end of
the spiral into the spiral coupler as shown.
3. Release the retaining clip.
Choose a Clockwise or Counterclockwise Spiral
1. The type of spiral used is determined by the column position it will occupy in the tray.
2. Refer to the figure below to find the correct spiral type.
Note: Bottle spirals are all clockwise.
Remove a Spiral Coupler
1. Pinch together the prongs on the end of the spiral coupler as shown.
2. Pull the coupler forward (in the direction of the arrow as shown)
PULL
LIFT
SPIRAL
RETAINING
CLIP
SPIRAL
COUPLER
A8 A9A0 A1 A2 A3 A4 A5 A6 A7
PRONGS
SPIRAL
COUPLER
PULL