|
|
| Getting Started | |||||
|
|
|
| |||||
Secure Rack | Modem | Version: 1.13 | Site: (undefined) | |||||
COMMANDS |
|
|
|
|
| |||
/H | Display | Help | Screen | /C | View Audit | Log | ||
/G | View/Set | General Parameters | /U | Utilities |
| |||
/M | View/Set | Modem Parameters | /X | Exit/Disconnect | ||||
/E | Edit | Password | Directory |
|
|
| ||
/D | View | Password | Directory |
|
|
| ||
Modem | Type: |
| MT2834ZPX |
|
|
| ||
Reset | String: | ATZ |
|
|
| |||
Init String: |
| AT&C1&D2E0Q1V1M1S0=1&E1&E15S13=0 |
| |||||
String: | (undefined) |
|
|
| ||||
MODEM | PORT SETTINGS |
|
|
| ||||
Baud |
| Rate: |
| 9600 | Result Codes: | Verbose | ||
Flow |
| Control: | RTS/CTS | Speaker: | On | |||
Local | Echo: |
| Off | Error Control: | On | |||
Rings | to | Answer: | 1 | Compression: | On | |||
Quiet | Mode: |
| On | Ignore DTR: | Off | |||
|
|
|
|
|
|
|
|
|
Figure 3.1: The SRM-100 Help Screen
For the purpose of this overview, it is only recommended to review the information on each menu in order to familiarize yourself with the unit; it is not necessary to actually enter parameters at the configuration menus at this time.
1.View/Set General Parameters: From the command prompt, type /G and press [Enter]. The General Parameters Menu will be displayed. This menu is used to set Console Port communication parameters, define the System Password, Console Port Password, and select other general parameters as described in Section 5.2. Press [Esc] to return to the Main Menu.
2.View/Set Modem Parameters: Type /M and press [Enter] to display the Modem Parameters menu. This menu is used to select communication parameters for the SRM's internal modem as described in Section 5.3. Press [Esc] to return to the
Main Menu.
3.Utilities Menu: Type /U and press [Enter] to display the Utilities Menu. This menu is used to access
4.Other Menus: At this point, commands such as "View Password Directory" and "View Audit Log" will not display much information. This is due to the fact that the Password Directory has not been defined yet, and the Audit Log has not had the opportunity to record connection activity. If you wish to display these menus, key in the appropriate command and then press [Enter]. To exit a menu, press [Esc] to return to the
Main Menu.
