| Operation |
7.6.4. Default Parameters
This option allows the system administrator to reset the unit to default parameters without deleting the Password Directory. To clear all menu selected parameters except the Password Directory, and return the
Notes:
•When the
•When the "Default Parameters" function is performed via modem, the SRM will not immediately reset modem parameters. The unit will reset all other parameters, wait for the caller to disconnect, and then reset modem parameters.
7.6.5. Send Test Message
This option allows the system administrator to send a test message via the Console Port or telecommunications line. If the SRM Command Mode has been accessed via the Console Port, the Test Message will be sent out the Console Port; if the Command Mode has been accessed via modem, the Test Message will be sent via the telecommunications line.
This Test Message is used to test communication with a remote device that has accessed the SRM Command Mode via modem, or to test communication with the local device connected to the Console Port. To send the Test Message, proceed as follows:
1.Access the SRM Command Mode as described in Section 5.1.
2.When the "SRM>" command prompt appears, type /U and press [Enter] . The Utilities Menu will appear as shown in Figure 7.2.
3.From the Utilities Menu, type 5 and press [Enter] .
a)If you have accessed the SRM Command Mode via the Console Port, the Test Message will then be sent out the Console Port.
b)If you have accessed the SRM Command Mode via modem, the Test Message will then be sent out the telecommunications line.
4.To terminate the Test Message, press the [Esc] key.
7.6.6. Upload Parameters
This function is used to restore SRM parameters that have been saved to an ASCII text file using the Utilities Menu's "Download Parameters" function. To restore saved SRM parameters, please refer to the instructions in Section 8.2.
