|
|
2.Console Port Password: When the Console Port Password is defined, the SRM will display a prompt before allowing access to the SRM Command Mode via the Console Port. (Up to 16 characters, Default = undefined).
Notes:
•If the Console Port Password is not defined, users are allowed to access the SRM command mode via the Console Port without a password.
•The same Password can be defined for both the Console Port Password and the System Password.
•The Console Port Password cannot be the same as a defined User Password. An error message will be sent if you attempt to define a Console Port Password that is the same as an existing User Password.
3.System Dial Back #: When defined, the SRM will dial this number before allowing command mode access via modem. If an inbound caller enters the valid System Password, the SRM will disconnect and then call the System Dial Back number. When the Dial Back number answers, the Command Mode will start. (Up to 32 characters, Default = undefined).
Note: While a Dialback operation is in progress, the SRM will not accept incoming calls or recognize commands entered via the Console Port.
4.Site ID: Defines a text string which is used to identify the SRM unit's installation site. (Up to 32 characters, Default = undefined).
5.Real Time Clock: Sets the SRM's internal real time clock and calendar. The SRM uses the Real Time Clock to determine times and dates when logging connection activity. Enter the correct time using 24 hour (military) format.
6.Console Port Communication: Defines the Baud Rate, Parity Bits, Data Bits, and Stop Bits for the Console Port. (Default = 9600 bps, No Parity, 8 Data Bits, 1 Stop Bit).
Note: If Console Port parameters are changed, new settings will take effect immediately, and may effect your ability to communicate with the SRM. Make certain to note newly selected parameters, and set your communications program to match.
7.Command Echo: Enables/disables the command echo. When enabled, characters sent to the SRM will be echoed back and shown on the display monitor. (Default = On).
8.No Activity Timeout: Selects the timeout value for all ports. If no data or command activity is detected during this period, the SRM will disconnect or exit from command mode. (Default = 5 Min.).
