Western Telematic SRM-100 manual General Parameters Menu, Super, Esc

SRM-100 - Secure Rack Modem, User's Guide								Set-Up and Configuration
GENERAL PARAMETERS:
1.	System			Password:				SUPER
2.	Console				Port		Password:	(undefined)
3.	System			Dial			Back #:	(undefined)
4.	Site		ID:					(undefined)
5.	Real-Time-Clock							Thu 03/08/2001 14:14:04
6.	Console				Port		Communication:	9600,N,8,1
7.	Command				Echo:			On
8.	No	Activity					Timeout:	5 Min.
9.	Password					Attempts:		3
10. Password on Dial Back:								Off
11.	Security					Mode:		On
12.	Audit		Log			Options:		All
13.	Dial		Back			Attempts:		1
14.	Dial		Back			Delay		30 Sec.
Enter		Selection,
Press		<ESC>			to abort ...

Figure 5.2: The General Parameters Menu

5.2. The General Parameters Menu

To access the General Parameters menu (Figure 5.2), activate the command mode, then type /G [Enter]. To change parameters, key in the number for the desired item, press [Enter], then follow the instructions in the submenu.

1.System Password: This password protects access to the Command Mode. When a caller connects to the SRM, a password prompt is sent. If the System Password is entered at this prompt, the caller will be granted access to the Command Mode. Note that the System Password is case sensitive.

(Up to 16 characters, Default = SUPER).

Notes:

•If the System Password is deleted or cleared, remote access (via modem) to the SRM Command Mode will be disabled.

•The same password can be defined for both the System Password and the Console Password.

•The System Password cannot be the same as a defined User Password. If you attempt to define a System Password that is the same as an existing User Password, an error message will be sent.

5-3