Windsor CSE24SP 10060260 3-18, Machine Operation, TO STOP SCRUBBING 1. BASIC AND CYLINDRICAL

TO STOP SCRUBBING

1. BASIC AND CYLINDRICAL

Raise the scrub deck, turn off scrub brushes.

Raise squeegee, turn off vacuum.

DELUXE

Press the one-touch switch (#1) on the control panel. The brush motors will stop and the scrub deck will rise to the park position. After 15 seconds the squeegee will raise, and 15 seconds later the vacuum motor will turn off. This delay is to clear the vacuum hose of recovered solution.

2.Allow the throttle pedal to return to neutral.

3.Turn machine power off.

FOR SAFETY: Before leaving or servicing

machine: stop on level surface, turn off machine and remove key.

MACHINE OPERATION

DOUBLE SCRUB

For floors which are heavily soiled or have thick accumulations of floor finish may not clean sufficiently with one pass. In these cases it will be necessary to double scrub.

To double scrub, make the first pass over the surface being cleaned with the squeegee up, vacuum off, the solution on, Aqua-Mizer removed and brushes down. This allows the solution to stay in contact with the soil while loosening the surface accumulation with the brushes. Allow time for the first application to stay in contact with the floor. Length of time between the first and second pass depends on amount of accumulation and the type of chemical being used. A second scrubbing with the squeegee down and again the solution and brushes on will further loosen soil. The additional application of solution will further assist the difficult cleaning job.

FOR SAFETY: When using machine, go slow on inclines and slippery services.

86037660 CHARIOT 11/09/06 3-18