MACHINE OPERATION
TO BEGIN SCRUBBING
When operating the machine around people, pay close attention for unexpected movement. Use extra caution around children.
Flammable liquids and/or reactive metals can cause explosions or fire! Do not pick up.
1.Place left foot on operator presence pedal. Throttle pedal must be in neutral position.
2.Turn machine power on.
3.Check position of Directional Control Switch to ensure that machine is set to travel in direction intended.
4.Press the Drive Reset Switch.
5.BASIC AND CYLINDRICAL Lower the squeegee.
Lower the scrub deck to floor.
DELUXE
Press the
6.Drive machine forward to begin scrubbing.
NOTE: Shut machine off immediately if water or foam is expelled from the machine.
7.Adjust the speed of the machine, solution flow and scrub brush pressure as necessary.
NOTE: Once solution flow rate is set it is not necessary to shut off solution when stopping scrubbing. Solution flow is automatically shut off when brush motors stop. When brush motors are activated, flow automatically resumes.
PRIMING PUMP
If the solution system has gone dry or has been unused for a period of time, it may be necessary to follow the pump priming procedure.
1.Fill solution tank.
2.Loosen, but do not completely remove the strainer bowl. Solution should flow out of the strainer. If it does not, check the strainer screen inside the solution tank. Insure it is clear of debris. Tighten the strainer bowl.
3.Disconnect the squeegee hose from the recovery dome.
4.Begin normal scrubbing and set the solution flow to maximum setting. Solution flow should begin within 2 minutes.
5.Connect squeegee hose to recovery dome.
6.Adjust the speed of the machine, solution flow and scrub brush pressure as necessary.
| 86037660 CHARIOT 11/09/06 |