MAINTENANCE-BAG REPLACEMENT
REMOVING BAG
1.Disconnect batteries and make sure parking brake is not overridden.
2.Under left front side of machine loosen hose clamp on recovery dump hose. Do not remove hose.
3.Remove Dome and set aside
4.Remove Float cage, loosen screw on elbow and remove elbow.
5.Remove the eight screws and nuts holding the bag clamps and set aside.
6.Remove clamps and set aside.
7.Pull mandrel from bottom of tank. Access can either be from the dirty water side or the clean water side or both. When replacing bag with new one be sure to save mandrel.
REPLACING BAG
1.Install mandrel in bottom of bag.
2.Place new bag in tank making sure hole for strainer basket is oriented properly.
3.Angle mandrel and bag into tank fitting toward front of machine. Push mandrel into fitting until it bottoms out.
4.Attach bag to top of machine by rolling edge of bag over clamp strips.
5.Replace elbow and float cage.
6.Tighten clamp on bottom of machine.
| 86037660 CHARIOT 11/09/06 |
