Wisdom Wands SC-1 owner manual Rear Panel, Channel Inputs,   , Pin 1: Chassis ground



L	R	C	SL	SR	SBL	SBR	Sub1	Sub2	Sub3		ON/OFF
										CAUTION--RISK OF ELECTRIC SHOCK--DO NOT OPEN
INPUT
										U.S. and n patents pending.
										Manufactured under license from Audyssey Laboratories.

MultEQ XT is a trademark of Audyssey Laboratories.

OUT							O 100-120V, 50-60 Hz, @ < 0.5A			FUSE REPLACEMENT
						SUB	O 200-240V, 50-60 Hz, @ < 0.25A			100-120V	200-240V
							Voltage set at factory for destination country			T 500mA L 250V	T 250mA L 250V
HIGH						OUTS
									in	out
OUT						SC-1 System Controller				s/n:
LOW						made in USA	USB	RS232	12v trigger
						www.wisdomaudio.com					~ AC INPUT
L	R	C	SL	SR	SBL	SBR

    

Please refer to owner's manual for fuse replacement

Caution!

Rear Panel

Turn off your power amplifiers before attempting to connect anything to your Wisdom Audio SC-1.

17.3 Channel Inputs

The SC-1 supports multichannel systems of up to 7.3 channel configura- tions; that is, you may have as many as seven main channels and three independent subwoofer channels controlled by the SC-1. These ten bal- anced audio inputs accept signals from a preamplifier/processor with balanced outputs via high quality XLR connectors.

The pin assignments of these XLR-type female input connectors are:

	Pin 1: Chassis ground
2 3 1	Pin 2: Signal + (non-inverting)
	Pin 3: Signal – (inverting)

Connector ground lug: chassis ground

These pin assignments are consistent with the standards adopted by the Audio Engineering Society. Refer to the operating manual of your bal- anced-output preamplifier to verify that the pin assignments of its output connectors correspond to your Wisdom Audio SC-1. If not, wire the cables so that the appropriate output pin connects to the equivalent input pin, in order to preserve the polarity of the musical signal.

Connect the output of your preamp/processor to these balanced XLR inputs. The inputs are in the following order, from left to right as seen from behind the SC-1: Left, Right, Center, Surround Left, Surround Right, Sur- round Back Left, Surround Back Right, Sub1, Sub2, Sub3.

13