Contents
Wisdom Audio System Controller SC-1
Owner’s Manual
RISK OF ELECTRIC SHOCK DO NOT OPEN
Important Safety Instructions
Table of Contents
North American Warranty
Care & Maintenance
Obtaining Service
Specifications
Unpacking the SC-1
PRECAUTION
Placement Considerations
Operating Voltage
Special Design Features
Since each channel of the amplifier is delivering current into its load only over a limited range of frequencies, several forms of distortion are reduced as com- pared to each channel handling the full range of musical information
2Setup Memory LED Indicators
1Power Switch and Indicator
Front Panel
3Setup Calibration Selector Switch
17.3 Channel Inputs
Rear Panel
Pin 3 Signal - inverting
27 Channel High Planar Output
43 Channel Subwoofer Output
37 Channel Low Woofer Output
6RS232 Interface
5USB Port
712v Trigger In and Out
8AC Mains Input, Switch and Fuse Assembly
1Check the AC cord to make sure it is not damaged
Introduction to Room Acoustics
•Smooth, consistent bass
•Stable, 3-dimensionalstereo imaging
•Center channel height
•Surround channel geometry
are all behind the listeners, creating a big “hole” in the soundfield between the front and the back
Suppliers of Acoustic Treatments
Books on Acoustics
Getting Ready to Calibrate
•the level trim for each loudspeaker channel, and
Wisdom System Configuration
Follow the on-screeninstructions, as shown below
When you select a particular speaker location, the chosen speaker will be high- lighted and the right-handpanel will change to show you the various possibili- ties available for that speaker, as seen below
A “GenSW” option is also provided, so as to accommodate the use of one or more non-WisdomAudio subwoofers
Page
Audyssey MultEQ Pro
Do not connect the microphone to the SC-1at this time, since feedback may result that could potentially damage your loudspeakers
Once you reach the Job Information screen shown above, you can safely con- nect the microphone to the SC-1
The Measurement screen is where MultEQ Pro collects the data it requires for accurate room correction. At this point, your installer will connect an XLR cable between the mic preamplifier LINE OUT connector and the Left input of the SC-1the top-leftcorner as seen from behind
phone was calibrated at “grazing incidence” and should point to the ceiling, not at any of the speakers
Measuring some distant corner where no one would be listening, or close to a room boundary such as a wall or floor, is actually counterproductive. It will compromise the quality of the resulting room correction
Distance can be displayed in feet, in milliseconds, or in meters cycle among these choices by clicking the blue underlined column label. Which one is best depends on the information your surround processor’s menu system needs. Use the appropriate value to set the distance delay in the preamp/processor
Once the room measurements are completed, MultEQ Pro calculates an equal- ization filter for each loudspeaker channel, including the subwoofers. The role of these filters is to achieve a particular frequency response within the entire listening area for each loudspeaker. This curve is determined based on several acoustical and program material considerations and is called a target or calibra- tion curve
boost in the bottom octave before you get too carried away with this setting
Once the software finishes calculating the optimal correction filters for the target curve you have selected, you will be presented with the Save Results screen shown above
Page
This response would blend nicely with a subwoofer, crossing over at 50 Hz. It would also be improved by moving the microphone around as you normally do, so as to give the system more information about what is going on in the room
Care & Maintenance
North American Warranty
Obtaining Service
Recommended minimum load impedance
Specifications
Wisdom Audio 1572 College Parkway, Suite
Dimensions
Notes
Wisdom Audio 1572 College Parkway, Suite
is a registered trademark of Wisdom Audio, Inc
Carson City, Nevada 89706 USA Telephone: Fax:
WSC1OM-1.04