WMF Americas 1400 Appendix Technical Data, machine should be installed with clearance of not

	Appendix: Technical Data
Mains voltage tolerance	230 V + 6 % - 10 %, mains outage < 50 ms no
	interruption of function
Water supply	3/8 inch flexihose connector with mains tap and
(optional constant water	filter on customer supply side, water temperature
connection)	max. 35 °C.
	min. 2 bar flow pressure ati 2 l/min., max. 6 bar
Water quality	For drinking water over 5° dCH (carbonate hard-
	ness) a WMF anti-scale filter should be included.
Drain outlet	Flexihose to DN 19, min. gradient 2 cm/m
(optional)
Ambient temperature	+ 5°C to max. + 35°C
	(Do not expose the coffee machine to frost).
Maximum humidity	80 % relative humidity without condensation,
	no water spray, do not use unit outdoors!
Protection	IP X0
Inbuilt clearances	For operating, service and safety reasons the
	machine should be installed with clearance of not
	less than 50 mm at the back and sides from the
	building or non-WMF components.
	A clear height of 100 mm from the top of the sup-
	porting surface should be ensured. Recommen-
	ded height of the working surface is a minimum of
	850 mm from floor level.
	If the machine connections are to be routed down
	through the counter, remember also to allow
	space for the connections. These may restrict the
	available space below the machine.
Anti-scale filter installed	490 mm (height) x 118,8 mm (diameter)
dimensions (03.9314.0001)	plus space requirement for the connection tubes

* The existing electricity supply must conform to the currently valid national rules (for Germany, VDE 0100).

To improve safety the coffee machine should be fitted with an FI 30 mA earth leakage current circuit breaker to EN 61008 standards. A plug top wall socket should be fitted near the machine. If the mains connection lead of this coffee machine is damaged it must be replaced by WMF Customer Services or a similarly qualified person.

If the coffee machine is permanently connected to the mains then an all-pole disconnecting separator (mains switch) to EN 60947 standards with a minimum 3 mm contact gap must be included. For flexible connection a separator switch is recommended.

Mains cable must not come into contact with hot surfaces.

Mains switch and plug top are part of the customer‘s on-site installation.

The machine may not have a fixed permanent mains connection if installed on any mobile furniture item.

User Manual WMF presto 59