Wolf ICBDD30 installation instructions OW N D R a F T Installation CON T R O L Module

Models: ICBDD30

1 74
Download 74 pages 11.89 Kb
Page 10
Image 10

WOLF D OW N D R A F T VENTILATION SYSTEMS

D OW N D R A F T INSTALLATION

CON T R O L MODULE

Set the downdraft into the opening. Extend the leveling brackets to the floor of the cabinet so the downdraft sits straight. NOTE: The leveling brackets can be removed and reattached in other positions. The flange of the leveling bracket may have to face inward in tight cabinet installations. Refer to the illustration below.

Secure the downdraft to the countertop by holding the downdraft against the back of the countertop cut-out and tightening the two mounting screws (one on each end of unit) on the underside of the countertop.

Screw the leveling brackets to the bottom of the cabinet. Tighten the screws holding the leveling brackets to unit on each side.

To reduce the risk of burns or ignition of clothing by reaching across burners, control module must be mounted at least 76 mm from edge of cooktop cut-out.

The remote-mounted control module and top cover are included with the downdraft. Also included are mounting brackets, RJ45 connec- tor and mounting hardware.

The control module can be located anywhere within reach of the 3 m power cable and a minimum of 76 mm from edge of cooktop cut-out. The remote-mounted control module is 60 mm x 168 mm and can be positioned horizontally or vertically in the countertop.

IMPORTANT NOTE: Do not place the module where it will be in the way of cooking, where hot pans may be placed or where hot liquids could be spilled on the controls.

mounting screws

leveling bracket – flange facing out

leveling bracket – flange facing in

Downdraft mounting brackets

10

Page 10
Image 10
Wolf ICBDD30 installation instructions OW N D R a F T Installation CON T R O L Module