Cutter Operation
When beginning operation of the cutter, make sure that all persons are in a safe location. Slowly move into the material with the tractor PTO set at 540 rpm (1000 rpm on "Q" models).
Mowing Tips
Look down and to the rear and make sure area is clear before operating in reverse.
Do not operate or transport on steep slopes.
Do not stop, start, or change directions sud- denly on slopes.
Use extreme care and reduce ground speed on slopes and rough terrain.
Watch for hidden hazards on the terrain during operation.
CAUTION
Stop power unit and equipment immediately upon striking an obstruction. Turn off engine, remove key, inspect, and repair any damage before resuming operation.
Maximum recommended ground speed for cutting or shredding is 5 miles per hour. Adjust tractor ground speed by using higher or lower gears to provide a clean cut without lugging tractor engine.
Tall material should be cut twice. Cut material higher the first pass. Cut at desired height at 90 degrees the second pass.
Remember, sharp blades produce cleaner cuts and use less power.
Before entering an area, analyze it to determine the best procedure. Consider the height and type of mate- rial to be cut and the terrain type (hilly, level or rough, etc.).
TRANSPORTING
The maximum transport speed for towed and
imum transport speed. Doing so could result in:
•Loss of control of the implement and tractor
•Reduced or no ability to stop during braking
•Implement tire failure
•Damage to the implement or its components.
Use additional caution and reduce speed when under adverse surface conditions, turning, or on inclines.
Never tow this implement with a motor vehicle.
1.Always transport with cutter in raised, locked position.
2.Raise cutter with hydraulic cylinder.
3.Rotate transport lock over cylinder rod.
4.Lower cylinder against transport lock.
5.To lower cutter for operation, extend hydraulic cylinder. Rotate transport lock back away from cylinder rod. Lower to desired cutting height.
Figure 9. Transport Lock Operation
STORAGE
Keep children and bystanders away from stor- age area.
ON MOUNTED AND
Disconnect cutter driveshaft and secure up off ground. Raise cutter with
ON
Raise cutter and block securely. Block wheels and raise tongue with jack. Disconnect hydraulic lines to optional cylinder. Disconnect driveline and secure up off the ground.
MAN0571 (Rev. 6/15/2007) | Operation 19 |
|
|
