U-Joint Assembly
1.Place seals securely on bearing cups. Insert cup into yoke from outside and press in with hand pressure as far as possible. Insert journal cross into bearing cup with grease fitting away from shaft. Be careful not to disturb needle bearings. Insert another bearing cup directly across from first cup and press in as far as possible with hand pressure.
2.Trap cups in vise and apply pressure. Be sure journal cross is started into bearings and continue pressure with vise, squeezing in as far as possible. Tapping the yoke will help.
3.Seat cups by placing a drift or socket (slightly smaller than the cup) on cup and rap with a hammer. See Figure 27. Install snap ring and repeat on opposite cup
4.Repeat Step 1 and Step 2 to install remaining cups in remaining yoke.
5.Move both yokes in all directions to check for free
movement. If movement is restricted, rap on yokes |
| ||
sharply | with a hammer to relieve any tension. |
| |
Repeat | until both yokes move in all directions |
| |
Figure 27. Install Cups | |||
without restriction. | |||
❖
MAN0571 (Rev. 6/15/2007) | Dealer Service 37 |
|
|
