Woods Equipment DS1260Q manual Front Half Figure Install Tongue, Install 3-Joint Driveline Figure

DS1260 & DS1440 Pull-Type Assembly (Continued)

FRONT HALF (Figure 29)

Install Tongue

1.Place tongue (1) between mast plates.

2.Place washer (26†) and sleeve (16) on cap screw (25).

3.Place washer (26) between mast plates and tongue, insert cap screw (25) with washer (26) and sleeve (16) through mast plates and tongue.

4.Secure with washer (26) and lock nut (27).

5.Attach front half of attitude rod (18) to lug on tongue using clevis pin (17) and cotter pin (33).

6.Raise front of cutter and install parking jack (6) to support tongue.

7.Attach safety tow chain (5) to tongue by wrapping chain around diagonal brace and threading the hook end back through the large link on opposite end of chain.

Install 3-Joint Driveline (Figure 29)

Install Driveline

1.Coat input shaft of gearbox with a light coating of grease.

2.Attach slip clutch on driveline (9) to input shaft of gearbox. Tighten cap screws (19) and lock nuts (20).

3.Attach rear tether chain on driveline to clip on plastic gearbox shield.

Install H-Frame

1.Place H-frame (2) in correct hole in bottom of tongue to maintain proper PTO distance (see Figure 29).

2.Secure H-frame to tongue using cap screw (23), two sleeves (3), two cup washers (4) and lock nut (24).

Attach Driveline to H-Frame

NOTE: Select holes in H-frame that will allow driveline to run level. Refer to Operation section for driveline height. Final adjustment will be necessary when cutter is attached to the tractor.

Place driveline bearing carrier between H-frame (2) and secure with clevis pin (7) and cotter pin (28).

Install Front Drive

1.Slide rear yoke of front driveline (8) over shaft of driveline (9) and align with notch on shaft.

2.Secure drives together using cap screw (21) and lock nut (20).

3.Attach tether chain on front half of driveline (8) to H-frame (2).

Install Drive Shield & Hose Holder

1.Attach drive shield (13) to driveline carrier bearing using two cap screws (32) and lock washers (31).

2.Attach hydraulic hose holder (15) to the top hole in H-frame (2) with cap screw (22), spacer (14), and lock nut (29).

MAN0571 (Rev. 6/15/2007) Assembly 41