Crossbar Installation
1.Using emery cloth (220 or finer), remove surface rust, and foreign material from hub, splined gearbox vertical shaft, and crossbar. See Figure 19.
Figure 19. Typical Crossbar and Gearbox Shaft
2.Install crossbar (2) on splined shaft. See Figure 20. Install nut (3). Torque nut to 450 lbs-ft. Install cotter pin.
Figure 20. Crossbar Installation
Crossbar Timing
Crossbar must be
1.To
2.The right crossbar will be at right angles to the front of the cutter.
3.Measure from the front of the cutter to the blade pin on left crossbar.
4.Hold crossbars in position while connecting the side drivelines.
Figure 21. Crossbar Timing - Bottom View
MAN0571 (Rev. 6/15/2007) | Dealer Service 35 |
|
|
