Woods Equipment DSO1260Q, DS1440Q, DS1260Q manual Install CV Driveline Optional

DS1260 & DS1440 Pull-Type Assembly (Continued)

INSTALL CV DRIVELINE (OPTIONAL)

Install Driveline (Figure 30)

1.Coat input shaft of gearbox with a light coating of grease.

2.Attach slip clutch on driveline (6) to input shaft of gearbox. Tighten cap screws (14) and lock nuts (15).

3.Attach rear tether chain on driveline to clip on plastic gearbox shield.

Install H-Frame

1.Attach H-frame mounting bracket (13) to cutter frame with carriage bolts (23), washers (24) and lock nuts (21).

2.Place H-frame (2) over bracket and align holes.

3.Secure H-frame to bracket using cap screw (18), two sleeves (3), two cup washers (4), and lock nut (19).

Attach Driveline to H-Frame

NOTE: Select holes in H-frame that will allow driveline to run level. Refer to Operation section for driveline height. Final adjustment will be necessary when cutter is attached to the tractor.

Place driveline bearing carrier between H-frame (2) and secure with clevis pin (5) and cotter pin (20).

Install CV Drive

1.Slide rear yoke of CV driveline (1) over shaft of driveline (6) and align with notch on shaft.

2.Secure drives together using cap screw (16) and lock nut (15).

Install Drive Shield & Hose Holder

1.Attach drive shield (10) to driveline carrier bearing using two cap screws (26) and lock washers (25).

2.Attach hydraulic hose holder (12) to the top hole in H-frame (2) with cap screw (17), spacer (11), and lock nut (21).

42 Assembly MAN0571 (Rev. 6/15/2007)