W1761/W1762 12" Table Saw with Riving Knife

SET UP

Table Insert

You must install the table insert before operating the table saw.

To install and adjust the table insert, do these steps:

1.DISCONNECT THE SAW FROM POWER!

2.Place the table insert into the table and tighten the M5-.8 x 20 flat head screw shown in Figure 26.

Note: Do not overtighten the table insert screw. If you have questions, contact Technical Support.

3.Place a straightedge across the table and the table insert.

4.Use a 3mm hex wrench and straightedge to adjust the table insert flush with the table as shown in Figure 27.

The table insert MUST be flush with the table top or the workpiece will hit the edge of the table insert at the beginning of the cut.

Table Insert

Screw

Figure 26. Table insert screw.

Figure 27. Adjusting the table insert.

Blade Guard & Splitter

You must install the blade guard and splitter before oper- ating the table saw.

To install the blade guard, do these steps:

1.

DISCONNECT THE SAW FROM POWER!

2.

Raise the blade up all the way, unscrew the screw

 

on the table insert, and remove the insert.

3.

Using an arbor wrench, loosen the hex bolt shown in

 

Figure 28.

4.

While lifting up on the splitter pawls, insert the

Splitter

Pawls

Bracket

Hex Bolt

splitter into the bracket slot, and tighten the hex

bolt to lock the splitter.

5. Reinstall the table insert and secure it with the

screw removed in Step 2.

Figure 28. Splitter installed.

-22-

Page 36
Image 36
Woodstock W1761, W1762 Table Insert, Blade Guard & Splitter, To install and adjust the table insert, do these steps