Installation
2–4 973-0031-01-01 Rev A

Pre-Installation

Location
Be sure to allow sufficient space for the Long AC Conduit Box to be mounted
directly adjacent to the inverter’s AC side. Be sure to leave room for expansion if
necessary. Also consider the additional weight and ventilation space requirements
of the Long AC Conduit Box.
Service Planning
If for any reason the inverter may need service or needs to be removed from the
position where it’s mounted, the following recommendations should be
considered to make this task easier.
To make servicing the inverter easier to accomplish:
Use flexible conduit.
When mounting the components such as the ACCB-L or DCCB-L next to the
inverter, bias the mounting screws away from the inverter. This will allow
"sliding" room within the mounting holes, so that the ends can slide apart
without being removed from their mounted position.
Figure 2-10, “Installing the ACCB-L to the SW Plus Inverter on Plywood” on
page 2–13 for details.
WARNING: Shock Hazard
Ensure that no DC voltage is being supplied to the inverter and that no AC voltage is
present on the AC wiring. Failure to do so could cause serious injury or death. A warning
label is provided to inform all personnel that multiple sources of power are available
inside. This label should be installed on the outside cover to be clearly visible. Ensure all
sources are OFF or disconnected before servicing.
Figure 2-1
Shock Hazard Warning Label
WARNING

ELECT RICAL SHO CK

HAZARD

THIS ELECTRICAL SYSTEM IS EQUIPPED WITH A
DC TO AC POW ER INVERTE R. DISCONNE CT THE
DC AND AC SOURCES BEFORE SERVICING.
PN 3550