Explosive gas precautions | Xantrex Technology ACCB-L-L1 specs

Safety

Explosive gas precautions

1.Working in the vicinity of lead-acid batteries is dangerous. Batteries generate explosive gases during normal operation. Therefore, you must read this guide and follow the instructions exactly before installing the Long AC Conduit Box.

2.To reduce the risk of battery explosion, follow these instructions and those published by the battery manufacturer and the manufacturer of the equipment in which the battery is installed.

Certifications

CSA certified to the following standards:

•UL 1741-2001 (First Edition), and

•CSA C22.2 No. 107.1-01

vi	973-0031-01-01 Rev A

Image 8

Xantrex Technology ACCB-L-L1 manual Explosive gas precautions, Certifications

Contents

Sine Wave Plus Long AC Conduit Box Owner’s Guide Page Sine Wave Plus Long AC Conduit Box Date and Revision Purpose ScopeAudience Organization Related Information Conventions UsedAbbreviations and Acronyms Important Safety Instructions Explosive gas precautions Certifications Contents Operation Figures Page Tables Xii Introduction Introduction 1The Sine Wave Plus ACCB-L Basic ACCB-L-L1 Specifications ACCB-L ACCB-L-L1 3ACCB-L Dimensions not to scale AC Bypass Switch Assembly For more information see , Operation in this guide Blockoff Plates 5Blockoff PlatesPage Installation Code Compliance Preparing for the InstallationInstallation Tools and Materials On-Grid Configurations Configuration PlanningOff-Grid Configurations Location Pre-InstallationService Planning Ventilation Requirements 12 305 mm Required Shock Hazard Warning Label 3Cover Removal and Replacement Removing and Replacing the Cover Installing or Removing the Blockoff Plates 4The Blockoff Plate on the Long AC Conduit Box Knockout Preparation 5SW Plus Inverter, AC Side Showing Knockout Location 6Knockouts Locations Installing Additional Breakers 7Installing Additional Breakers on the DIN Rail Mounting Mounting on the Xantrex Back Plate XBP 9Installing the ACCB-L on the Backplate Mounting on Plywood To mount the Long AC Conduit Box on plywood Wiring General Wire Sizes and Disconnect Requirements 1Torque Values for Wiring 11ACCB-L Approved Internal Components 12ACCB-L-L1 Internal Components Factory installed Installation Wiring for Off-Grid Applications Single Inverter Configurations 120 Vac Installation Step-down Configurations 240 Vac to 120 Vac Installation Step-up Configuration Deep Well Pump 120 Vac to 240 Vac Dual Inverter Configurations 120 Vac and 240 Vac Wiring for On-Grid Applications 20Wiring an On-grid Application Using a Single Inverter Installation Step-up Configurations Utility Backup 120 Vac to 240 Vac Dual Inverter Configurations 120 Vac and 240 Vac Additional Accessory Wiring 24Accessory Wiring for Single-Inverter Configurations 25Accessory Wiring for Dual-Inverter Configurations Operation AC Bypass Switch Operating the AC Bypass Switch Normal Operation Bypass Operation Dual Inverters 240 Vac Loads AC Input/Output Off Warranty and Return Information Warranty Exclusions DisclaimerProduct Out of Warranty Service Return Material Authorization PolicyReturn Procedure Information About Your System Serial Number Purchased From Purchase Date Index IX-2 Rev a Page Xantrex Technology Inc