Installation
Mounting the Inverter on the Bracket
Before mounting the inverter, it is recommended to remove the communication ports cover. With the cover removed, you can access all the mounting slots along the bottom flange.
Mounting a Single Inverter
To mount the inverter on the mounting bracket:
1.Place the GT Inverter’s mounting hook, located on the back of the enclosure, over the bracket and ensure the inverter is seated properly, as shown in Figure
2.After the unit is correctly seated on the bracket hook, locate the mounting slots at the bottom of the unit, and mark the location on the wall for securing screws.
3.Remove the inverter and drill pilot holes in the wallboard or siding for the securing screws.
4.Reinstall the GT Inverter on the bracket and secure the bottom of the unit with appropriate screws or anchors, and tighten.
Slide the mounting hooks on the inverter over the hooks on the mounting bracket.
Ensure the inverter is seated properly on the mounting bracket
flange with |
|
|
mounting slots | 130 cm (51") | 100 cm (39") |
Figure