Monitoring the Inverter
Monitoring the Front Panel Display
During startup
During waiting period
During operation
When the inverter is offline or there is fault condition
During startup, the inverter’s front panel liquid crystal display (LCD, see
Figure
When the protection timer begins, the inverter displays “Reconnecting in sss seconds” (see Table
When the protection timer stops, the GT Inverter begins selling power, indicated by the power output reading in the display (see Table
When the GT Inverter is offline (for example, at night) or a fault condition has been detected, the LCD shows a message screen to indicate that state. The specific fault condition will be identified. See Table
Important: The values in the front panel LCD are not user adjustable.
Front panel LCD | Tap Xantrex logo for |
| backlight/status screens. |
| Figure |
Viewing more | Additional screens of information about the performance of the GT Inverter can be |
information | displayed by tapping the Xantrex logo on the inverter front panel. This causes the |
| LCD to cycle through a series of information screens in Normal Operation, |
| Offline or Fault modes. These are described in detail in the following section, |
|