Installation

To wire the Remote Monitor to the Sun Tie XR:

1.Route the Remote Monitor’s six-conductor cable separate from the other wiring to prevent noise and interference from being introduced into the data cable. Refer to Figure 2-17and Figure 2-18. The connector is located in the upper right-hand section of the wiring compartment.

CAUTION

When routing the Remote Monitor cable, do not use a metal conduit. Metal conduit may induce noise in the remote cable and cause scrambled data to appear on the display.

2.Run the cable through one of the lower knockouts (with a strain relief installed) and plug it into the Remote Monitor port.

3.Recheck all wiring and reinstall the panels and the Rain Shield (if used).

CAUTION

The P.C. com. port next to the Remote Monitor port is not enabled. Connecting a computer to this port may result in damage to the inverter or the computer.

Remote Monitor port (located on top of wiring access compartment)

Figure 2-17 Location of optional Remote Monitor port

975-0053-01-01

2–23