Xerox 4110, 4590 manual Power on/off, may be referred to simply as the Finisher

2. Product Overview

No.	Component	Function
36	Punch scrap container	Collects the scraps from the puncher. Open to remove the scraps.
37	Tri-Fold output tray	Receives copies when you select Tri-Fold In or Tri-Fold out.
38	Tri-Fold output tray button	Press this button to open tri-Fold output tray.
39	Left cover.	Open this cover to access the machine and to clear paper jams.
40	Staple cartridge storage	Staple cartridge for replacement can be stored.
	space
		NOTE 1: Throughout this guide, Finisher D and Booklet Finisher D
		may be referred to simply as the Finisher.
		NOTE 2: Throughout this guide, the Duplex Automatic Document
		Feeder is abbreviated as "Document Feeder.”

Power on/off

Switch on the power before operating the machine. The machine warms up in approximately five minutes after which you can make copies. Switch off the machine at the end of the day or when it is not in use for a long period of time. Use the Power Saver feature to reduce the power consumption of the machine.

For information about power saving feature, refer to “Power Saver mode” on page 2-7.

Power on

Perform the following to power on the machine: 1. Open the cover.

2. Press the power switch to the on position [].

NOTE: The "Please wait..." message on the UI indicates that the machine is warming up. The machine cannot be used while it is warming up.

2-5 Xerox 4110/4590 Getting Started