Xerox D60327 Choose Configure Downstream PUs, Choose Configure LUs for Downstream PUs

SNA IPDS and SCS Priting from MVS or VM

Xerox 4500 PS TR

c)Press <Enter> on <Configure default LU attributes>

d)Select:

Dedicated Printer

<VTAM LU Name Prefix> (the name defined in VTAM) <Hex> or <Decimal> (system dependant)

<ESC>

e)Enter <Starting dependent LU address>

(Make sure that the number is not already in use by the existing profile)

f)Enter <Number of dependent LUs>

(This number should reflect the number of Xerox 4500 PS TRs that will connect to this SAA gateway. Each Xerox 4500 PS TR uses one LU)

g)Enter the rest of the parameters. They should be copied from the existing PU profile.

h)NOTE

The value for ‘802.2 Local Service Access Point’ must be defined in the Xerox 4500 PS TR as ‘Remote SAP’.

The value for ‘node id’ must be defined in the Xerox 4500 PS TR as ‘Block number’ (first three digits) and ‘ID number’ (last five digits).

i)Press <ESC> and choose <YES> to create a new PU profile

5.Choose Configure Downstream PUs

This is where you actually define each of the Xerox 4500 PS TRs to the SAA gateway.

Each Xerox 4500 PS TR is considered a PU.

a)Press <insert>

b)Enter <downstream PU name> (e.g. ida01)

c)Enter <downstream LU address> (always 02)

d)Enter <Number of downstream LUs> (always 1)

e)Enter <Logical Adapter Name> (the name of the SAA logical ada pter that should be used to communicate with the Xerox 4500 PS TR In the above figure it would be the Token Ring adapter. If you have created a new Data Link Adapterin step 3), this is the one.

f)Enter <MAC address> and <802.2 remote node address> (The MAC address of the Xerox 4500 PS TR)

g)Leave the rest of the parameters at default value, press <ESC> and choose <YES> to create a downstream PU.

h)NOTE:

The <802.2 remote service access point> is the ‘Local SAP’ in the Xerox 4500 PS TR.

6.Choose Configure LUs for Downstream PUs

a)Press <enter> on the highlighted line showing: 002 (0x02)

b)Choose <Host PU profile>

131